LevelOne MIDSPAN POH-0850TX Manuel d'utilisateur

POH-0850TX 19” 8-port MidSpan POE HUB USER MANUAL

8 8. If you want to remove the software utility, go to “Star”  “Control Panel”  “Remove/ Add application”

9 4. GUI Management Connecting to PoE Connecting the PoE with PC through the consol

10 device current configuration to the utility system and enable auto refresh function.  Port Specific Con

11 System Information  Chip Version: display the system chipset version and revision information.  Firm

12 Figure 4-4 Device Setting interface

13 Port Specific Control  Port Enable: enabling the port. This function is co-responding with “Master Ena

14 The LED indicator will change depends on the PD status.  Green: It represents PD is connecting with the

15 Parametric Information  Discovery R (ohms): display resistance value.  Port Current (mA): display cu

16 5. Technical Specification Standard IEEE802.3af Power over Ethernet Connector Data in: 8 x RJ-45, Dat

17 Parametric information It will show current PD parameters which include Discover-resistor detected value,

i Contents 1. Introduction ...1 Features...

18 6. Appendix Console Port Pin Assignments The female DB-9 serial port on the POE hub front panel is us

19 Console Port to 9-Pin DTE Port on PC Switch’s 9-Pin Serial Port CCITT Signal PC’s 9-Pin DTE Port 2 RXD

1 1. Introduction Power-over-Ethernet (PoE) eliminates the need to run 110/220 VAC power to other devices on a wired LAN. Using Power-over-Ethernet

2  Remote power feeding up to 100 meters and for IEEE802.3 10Base-T, IEEE 802.3u 100Base-TX standard  Ce

3 2. Hardware Description This Section mainly describes the hardware of the POH-0850TX, and gives a physic

4 Figure 2-2. LED indicators LED Status Color Description On Green Power is transmitting to the

5 side of power cord connects to the power outlet. The internal power supply of the Switch works with voltag

6 3. Software Utility Installation Berfore you star to remote configuring PD, please intsall the software

7 Figure 3-2 6. When installation finishes, click “OK” button to finish. See Figure 3-3. Figure 3-3 7.