LevelOne FCS-3091 Manuel d'utilisateur télécharger pdf (Page 55)

Intelligent Surveillance Solution

LevelOne IP CamSecure

- 54 -

3.3 Encoding Option

3.3.1 Pre-record/ Post-record Time

The pre-record/ post-record function saves the recording data accordingly. For instance, to set up a 5

second pre-record time means the system will start saving the recording data 5 seconds before the event

happens.

Note:

The maximum of pre-record/post record period is 60 seconds.

3.3.2 Record Mode

Always Record:

Select this option to record the video continuously.

Record on Event: * Some options are not available under Lite License

Select this option to obtain the “Select Event” panel. From the Smart Guard list,

check the camera events or digital inputs to trigger the recorded action. Click OK.

Note: Please note it is required to enable ”Smart Guard” from the Main Console

panel before configuring “record on event” to trigger recording.

*Smart Guard is only in IP CamSecure Pro.

Record on Motion:

Select this option to start recording when motion is detected. Adjust sensitivity, the

frame interval and zone to setup motion detection. To setup a single detection

zone, left-click and drag the mouse to draw a rectangle. To setup more than one

detection zone, simply repeat the same process or click “All” to select the entire

screen.

Note: The maximum number of rectangle detection zones is 10.

3.3.3 Encoded Options

This option sets up the quality of the recorded video. The “Original Video” window is the original stream from

the camera. The “Encoded Video” is preview of the recorded video corresponding with the encode settings

below.

Original Video Encoded Video

Video Encoder Record Mode Time Option

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 138 139

Pas de commentaire

LevelOne FCS-3091 Manuel d'utilisateur Page 55