LevelOne FCS-5011 Manuel d'utilisateur télécharger pdf (Page 7)

Hardware Reset

There is a reset button on the inner side of the Network Camera. It is used to

reboot the Network Camera or restore the Network Camera to factory default.

Sometimes rebooting the Network Camera could set the Network Camera

back to normal state. If the problems remain after rebooted, restore the

Network Camera to factory default and install again.

Reboot: Press and release the reset button. The status LED will blinks two

short one long in red.

Restore: Press the reset button continuously for over 5 seconds until the

status LED blinks two short one long in red. Note that all settings will be

restored to factory default.

Installation

Hardware installation

Follow the steps below to install the Network Camera:

1. Open the lens cover.

1 2 3 4 5 6 7 8 9 10 11 12 ... 118 119

Pas de commentaire

LevelOne FCS-5011 Manuel d'utilisateur Page 7