Levelone WPC-0100 Manuel d'utilisateur télécharger pdf (Page 12)

Additional Note for Windows NT4.0

The installation procedure under Windows NT4.0 will be a little different from Windows

98 shown below. It will be change after step10 refer to the installation of Windows 98.

1. Click “ OK “ and system will auto-select I/O address and IRQ and remind you to

choose the unused I/O address and IRQ from Windows NT Diagnosis to prevent

system resource conflict.

2. If the Ndis 3.0 packet driver has already existed in your system, the setup message

will be prompted as follows, just click “ OK “.

3. A prompt of networking setting will appear as follows. It’s the same as Windows 98

operating system.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

Pas de commentaire

Levelone WPC-0100 Manuel d'utilisateur Page 12