LevelOne WAP-6101 Manuel d'utilisateur télécharger pdf (Page 33)

WPA-6101 300Mbps Wireless Ceiling Gigabit PoE Access Point

5. SNMPv3 Settings: User 1/2: This device supports up to two SNMP

management accounts. You can specify the account permission as “Read” or

“Read/Write” respectively.

6. User 1/2 AUTH Mode: Select MD5 or SHA as the method of password

encryption for the specified level of access, or to disable authentication.

7. User 1/2 Privacy Mode: You can configure the SNMP privacy mode. There are

three modes for you to choose: “noAuthNoPriv” for both authentication and

private key are not required, “authNoPriv” for no private key required, and

“authPriv” for both authentication and private key required.

8. Username 1/2: Use this field to identify the user name for the specified level of

access.

9. Password 1/2: Use this field to set the password for the specified level of

access.

10. User 1/2 Priv Key: Use this field to define the encryption key for the specified

level of access.

11. Trap Event Receiver 1 ~ 4: Enter the IP addresses or Domain Name of your

SNMP Management PCs. You have to specify the IP address, so that the device

can send SNMP Trap message to the management PCs consequently.

3.3 System

In this section you can see system information, system logs, use system tools for system

update and do service scheduling and system administration setting.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 48 49

Pas de commentaire

LevelOne WAP-6101 Manuel d'utilisateur Page 33