LevelOne WAP-6150 Manuel d'utilisateur télécharger pdf (Page 16)

Configure Slave AP via WEC Button

Step 1

Check 2.4GHz LED of Access Point which acts as Master Mode. It should be Green. If not,

please use WEC button to switch into Master Mode.

Step 2

Check 2.4GHz LED of Access Point which acts as Slave Mode. It should be Amber. If not,

please use WEC button to switch into Slave Mode.

Step 3

Click WEC Button (about 1second) of master AP and any slave AP as one pair

simultaneously

Step 4

WiFi LED of Master and Slave AP will flash and Negotiate WiFi Profile Configuration. This

Process will finish within 30~60 sec. Then WiFi LED will be Solid.

※If Negotiation failed or Master or Slave AP don’t existed, WiFi LED will Flash 2 min

then will be Solid. Please try again

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

Pas de commentaire

LevelOne WAP-6150 Manuel d'utilisateur Page 16